On the other hand for a Dashcam i used for many years as my R side camera, it was stuck to the back of the B pillar, and actually only about 1/3 of the small pad was engaged on the trim plastic, and it never come off and it have even been bumped several times by people getting in and out the back of my car.Īs i recall 3M have pretty comprehensive info on their products, but also have a lot of them, so finding just the right tape reading those might also be a drag.įor the best in store knowledge you are probably best off looking for the tape in a arts and craft store, large supply stores probably have some too, but it is rare their people have knowlege of such a small product. I have a gauge / remote for a 12 V splitter in my car, the provided sticky tape for it grip like a SOB on the dash / center console, but the grip on the smother back of the extremely light remote have come loose long ago, and that's the provided sticky pad. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.It is somewhat counter intuitive that something sticky "only" work on a smooth surface and not so good on a surface a little more rough. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. Not for consumer sale or use.ģM industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Vigorous scrubbing may be required.įor industrial/occupational use only. For use on many plastic, rubber, painted and bare metal substratesģM™ Tape Primer 94 may be applied with a brush, swab, pressurized flow gun, knurled roller or similar type of equipment and can be removed with isopropyl alcohol. Allow your first application of primer to dry before applying a second coat. FREE delivery Wed, Jan 24 on 35 of items shipped by Amazon. 899 (0.58/Foot) Save more with Subscribe & Save. Special note: porous surfaces may require 2 applications for uniform coverage and good adhesion. Double Sided Tape,Heavy Duty Double Sided Tape,15.4FT Length, 1/2 Inch Width for Car, LED Strip Lights, Home Decor, Office Decor, Made with of 3M VHB Tape (1/2in15.4FT) 645. Allow the primer to dry completely, which is usually accomplished in 5 minutes at room temperature, before applying tape. Promote adhesion of 3M VHB Tape For use on many plastic, rubber, painted and bare metal substrates Application Tips 3M Tape Primer 94 may be applied with a brush, swab, pressurized flow gun, knurled roller or similar type of equipment and can be removed with isopropyl alcohol. It's important to use the minimum amount of product necessary as over applying can cause sub-optimal results. The primed surface must remain free from contaminants prior to applying the tape. Make sure your surface is clean and dry before applying a thin, uniform coat of 3M™ Tape Primer 94. 3M™ Tape Primer 94 is used to improve overall adhesion of tape, film and vinyl graphics Dries in Minutes for Efficient Use
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |